Updated on 12/24/2019
DoubleCAD User Manual Publication
DoubleCAD User Manual : Tube Flange
Direct link to topic in this publication:

DoubleCAD User Manual : Tube Flange

Available in TurboCAD Platinum only_

Adds a bend onto a solid (ACIS) cylinder.

  1. Start with a cylinder, and activate Tube Flange. Select the cylinder you want to bend. The next click defines the end where the flange will be added.

  2. The next click defines the , which defines the direction of the bend, relative to the axis of the cylinder.

  3. This angle can be set in the Inspector Bar as well. You can also define the Radius and Angle here.

    The Neutral Depth is the distance into the depth of material, along which there will be no tension or compression. Flange Length is the length of the new material beyond the current end of the cylinder.
    The preview shows how the final result will look. You can still make changes to any value in the Inspector Bar.

  4. Select Finish from the local menu or Inspector Bar to complete the bend.

    You can use this tool multiple times on the same cylinder.